|
Post by texoutsider on Feb 20, 2014 11:35:10 GMT
Posts: 226 View Profile Header tethers « on: February 19, 2014, 09:23:33 PM » Looks like NHRA in a rare case came to its senses to some extent. classracer.com/classforum/showthread.php?t=51915Still need to put a muffler hanger to your removable collector though
|
|
|
Post by hillbilly on Feb 20, 2014 13:54:45 GMT
SO all we need is exhaust hangar and a muffler clamp per collector. Anybody want to buy a Tether Kit....
|
|
|
Post by texoutsider on Feb 20, 2014 14:08:00 GMT
Oh Noooooooooooooooooo...I'll bet "shes' Furious" over that one...hahahahahahhahahahaahahahaha
sorry Bill...could not help myself.
|
|
|
Post by hillbilly on Feb 20, 2014 15:14:00 GMT
I'm not going to tell her....LOL... Beer mE!
|
|
|
Post by Fugly on Feb 20, 2014 19:07:36 GMT
And here I was buying up all the gp medium tent tethers for Fugly.....
|
|
|
Post by hillbilly on Feb 20, 2014 22:27:51 GMT
Ya want 1 more
|
|
|
Post by Fugly on Feb 20, 2014 23:04:02 GMT
They gotta be real big fer da ugly
|
|
|
Post by hillbilly on Feb 20, 2014 23:55:09 GMT
huh....it's all "real big" in texas...right...(my 11" tether aint worthy)...LMAO
|
|
|
Post by Fugly on Feb 21, 2014 0:33:40 GMT
Here it is from the Nhra website amendments: SECTION 20: GENERAL REGULATIONS, ENGINE: 1, 1:3 EXHAUST (Page 3) All must be equipped with exhaust collectors, headers, or stacks installed to direct exhaust out of car vehicle body to rear of car, away from driver and fuel tank. No part of the exhaust system may be routed through the driver’s compartment. Exhaust must be securely fastened (i.e., metal connector straps, bolted, welded, etc.) to prevent loss of collector/stacks system components during competition. Effective Jan. 1, 2014, All removable multi-piece exhaust collectors/stacks must be securely fastened with either an NHRA-accepted header tether a minimum 1⁄2” (half-inch) stitch weld located on each primary tube (2/18/2014) cars vehicles collectors/stacks system components , or or be permanently attached to the vehicle body or frame with positive fasteners (i.e. exhaust hangers, support brackets, bolts/nuts, etc.) such that they require tools for removal. to prevent loss of
|
|
|
Post by texoutsider on Feb 21, 2014 6:42:01 GMT
I am going to use a "tether" cable to tie my collectors to the body...lol
|
|